Good luck.
On Apr 18, 2013, at 1:48, "Claessen, John" <john.claessen AT kpn DOT com> wrote:
> Hi Stanley,
>
> Thanks, but like I said, they are already working on it.
> But since it's taking them a week now, I thought I'd ask here.
>
>
> John.
>
>
> -----Original Message-----
> From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
> On Behalf Of Stanley R. Horwitz
> Sent: woensdag 17 april 2013 16:45
> To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
> Subject: Re: [Networker] NDMP backup not making any I/O
>
> Ask EMC to engage a Celerra engineer on this issue. There might be a hardware
> or firmware problem on the data mover.
>
> On Apr 17, 2013, at 10:25, "Claessen, John" <john.claessen AT KPN DOT COM>
> wrote:
>
>> Hi,
>>
>> We are facing NDMP backup issues.
>>
>> Situation:
>> Backups from Celerra NAS using NDMP to a VTL on a DataDomain. Connections
>> are fine.
>> Tape is loaded but no I/O. After a while a new share is tried but same
>> result.
>> This only occurs on one datamover, the other two are just fine.
>> Configuration on all datamovers (and clients) is the same.
>> NetWorker is checked out completely and we are convinced that's it's not an
>> NW issue.
>>
>> EMC is working on it and even made it worse, it used to be just one share
>> with this problem but now it's the whole datamover.
>> Any suggestions......?
>>
>>
>> John.
|