[Networker] Tape read problem
2013-01-24 13:15:44
The issue obviously is that you load one drive but for reading/writing you
'talk' to another one. This can happen if you run jbconfig and do not obey the
device sequence.
Run the inquire command and verify the device names.
Then delete the jukebox and devices and reinstall it again with the exact same
sequence.
You can also verify which tape drive is loaded by running the command "mt -f
<device_name> status" .
Usually, this is easy to fix. Good luck.
+----------------------------------------------------------------------
|This was sent by carsten_reinfeld AT avus-cr DOT de via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
|
|
|