George

On 2012-10-01 16:30, Bowersock, Bryan wrote:

Right-click in the Save Sessions tab on one of the column headings, choose Add Columns>>>  Volume.  
Or you can "Choose Table Columns..." and click the checkbox for "Volume".



Bryan Bowersock
Storage Administrator - Tampa, FL



-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On 
Behalf Of George Sinclair
Sent: Monday, October 01, 2012 4:07 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: Re: [Networker] How can I see both volumes and save sets in nmc?

On 2012-10-01 15:34, bingo wrote:

Just go to the 'Save Sessions' tab and click the headline. Then select the 
appropriate columns.
That's it.

Maybe I wasn't clear in my post. I'm under Monitoring, and I select the 'Save 
Sessions' tab, but that doesn't show me the volume names. Instead, it reports 
the following columns:

Client Name, Save Set, Group, Level, Start Time, Duration, Device, Rate (KB/S), 
Size

I also want to be able to see the affected volumes that are being written to 
with their respective save sets. How can I report all of that so I don't have 
to keep jumping back and forth between windows? Is there anything in nmc to 
mimic the nwadmin Sessions window?

+---------------------------------------------------------------------
+-
|This was sent by carsten_reinfeld AT avus-cr DOT de via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+---------------------------------------------------------------------
+-

--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or 
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -

--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or 
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -