Re: [Networker] Pool volumes with available space being ignored - why?
2012-08-29 10:08:23
Thanks Bingo
How do I verify the storage node list? There is an old M1800 library
and server configured as a storage node in addition to the 'main' SL500
library. I have been trying to scan in the 'old' M1800 SDLT Type II tapes .
The set-up looks like this
backup-main server - SL500 tape library attached.
backup-old server - M1800 tape library attached. (Configured as a
storage node of backup-main)
Scanning from backup-old to backup-main.
The clients from the backup-old server have been added to the client
list on the backup-main server as M1800-xyz. Bingo, as you mention that
the storage node list for the clients is not right - what should the
storage-nodes parameter for the M1800-xyz clients be? Its currently set
to "nsrserverhost".
Thanks for your help.
Paul
On 24/08/2012 02:30, bingo wrote:
Each NW host uses the ports 7937 and 7938 (for the built-in portmapper). Make
sure that these are available before you start nsrexecd.
NW has the intention to repeat error messages more than necessary. Some appear
about 50..60 times/s. You can not change this.
Probably, the storage node list for the clients is not right so the media is
expected at another (remote) SN.
+----------------------------------------------------------------------
|This was sent by carsten_reinfeld AT avus-cr DOT de via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
|
|
|