[Networker] Need to obtain the jobid of a client initiated save via command line reliably
2012-08-23 15:13:57
We have several oracle databases that are not RMAN. We have a script that
monitors the archive directories, and initiates a backup once they get to a set
threshold. This has been running for several years on Data Protector. I'm
working to migrate this same logic to Networker.
I need to initiate a save session from the client, then be able to periodically
check the status of that save session. I know jobquery is the best place to
get the status of a backup. Any thoughts as the best way to initiate a manual
save, and then obtain it's job id so you can periodically check it's status.
I've came up with a few ways, but none so far are 100% reliable in obtaining
the correct job id while other backups are running at the same time.
What sucks is that when the save job is initiated from the client, the amount
of information that can be obtained from the save job attribute in jobquery is
limited.
Justin M Roberts
GE Appliances and Lighting
TAS Midrange Services
T +1 502 452 4136
M +1 502 494 5728
F + 1-502 371 8271
justin.roberts2 AT ge DOT com<mailto:justin.roberts2 AT ge DOT com>
www.ge.com<http://www.ge.com/>
Appliance Park AP4-300
Louisville, KY 40225 USA
General Electric Company
GE imagination at work
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Need to obtain the jobid of a client initiated save via command line reliably,
Roberts, Justin (GE, Appl & Light) <=
|
|
|