Re: [Networker] Group shows as failed in GUI but clients are all successful
2012-02-28 20:55:15
Hi,
If you enable 'Diagnostic Mode' and look at the 'Status' tab for that group in
'Configuration' task, do you see any failed save sets in the 'Completion'
attribute in that tab?
Regards,
Sukarna
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of brainofa
Sent: Tuesday, February 28, 2012 6:14 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Group shows as failed in GUI but clients are all successful
Currently running 7.6.1.6
+----------------------------------------------------------------------
|This was sent by andrew.j.wendler AT questdiagnostics DOT com via Backup
Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or via RSS at
http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|