Re: [Networker] How to mark a tape full?
2011-09-07 21:57:07
George,
Just curious, but why would you care if a tape at 100% of the estimated
capacity is marked full or not? If you want to prevent a piece of tape media
from being written to, you can always mark it as read only in NMC.
On Sep 7, 2011, at 8:46 PM, George Sinclair wrote:
> Is there a way to mark a tape full (%used 'mminfo' value)?
>
> I think if a volume is reported as full, and I use nmc to change the mode to
> 'Appendable' (Media->Volumes->Select volume->Change Mode->Appendable),
> NetWorker will change its '%used' value back to 100%. Any way to change it
> back to full again?
>
> Thanks.
>
> George
>
> --
> George Sinclair
> Voice: (301) 713-3284 x210
> - The preceding message is personal and does not reflect any official or
> unofficial position of the United States Department of Commerce -
> - Any opinions expressed in this message are NOT those of the US Govt. -
>
> To sign off this list, send email to listserv AT listserv.temple DOT edu and
> type "signoff networker" in the body of the email. Please write to
> networker-request AT listserv.temple DOT edu if you have any problems with
> this list. You can access the archives at
> http://listserv.temple.edu/archives/networker.html or
> via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|