Re: [Networker] EMC CDL robot unavailable after upgrade to 7.5.1
2010-02-02 16:10:18
Hey doc,
With 7.4.x and above you need a "Virtual Tape Library Capacity" license in
order for a vtl to work. I'm not sure if that would cause you to not be able
to see the library, but it's worth looking into. I remember when I created my
2nd datazone I had probs with the library until I had that license.
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of mark wragge
Sent: Tuesday, February 02, 2010 2:18 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] EMC CDL robot unavailable after upgrade to 7.5.1
Hi. I have upgraded a solaris 9 server from networker 7.3.2 to 7.5.1. The
upgrade appears to have been successful except that the CDL virtual tape
library will no longer function.
After investigation it appears that the CDL Library Robot is no longer visible
by the networker server. When I run the inquire command it returns almost
immediately with no output. I ran an inquire command before the upgrade so it
was definately working then.
I have checked that the fibre card can see the CDL and i believe it can using
lputil as the WWN is listed as online. I believe that the CDL 4 Virtual tape
devices are online using other command line tools (cant use inquire!).
I have also upgraded some storage nodes that use the EMC CDL and they can see
the tape devices successfully. It appears that the Virtual RObot is causing the
porblem.
Persistent bindings were configured on all fibre devices before the upgrade.
Any advice on where this problem is originating and how i can resolve it?
Thanks, Mark
Send instant messages to your online friends http://uk.messenger.yahoo.com
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|