Re: [Networker] Port numbers for NMC?
2009-10-16 11:57:06
Francis Swasey wrote:
On 10/15/09 7:16 PM, George Sinclair wrote:
1. I thought I remember reading somewhere - maybe on this listing -
about some command to set ports that you're supposed to run before
installing NW on the server? Maybe that was something else entirely?
I assume you are referring to the nsrports command -- that is for the
NetWorker server software itself and is not relevant to NMC.
2. Do most folks use the defaults?
I do.
3. I assume the installation will prompt for these?
It will.
4. Best way to change these values later?
I never have. What version are you installing.... NW7.5's NMC uses a
different configuration than the previous versions did.
It will be 7.5SP1 on Linux.
Thanks.
--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|