Sorry.  3yr old + cell phone.

-----Original Message-----

From:  ted.reed AT sprint DOT com
Subj:  Re: [Networker] Port numbers for NMC?
Date:  Thu Oct 15, 2009 19:34
Size:  1K
To:  "EMC NetWorker discussion" <NETWORKER AT LISTSERV.TEMPLE DOT EDU>;"George 
Sinclair" <George.Sinclair AT NOAA DOT GOV>;"NETWORKER AT LISTSERV.TEMPLE DOT 
EDU" <NETWORKER AT LISTSERV.TEMPLE DOT EDU>

Oeiei

-----Original Message-----

From:  "George Sinclair" <George.Sinclair AT NOAA DOT GOV>
Subj:  [Networker] Port numbers for NMC?
Date:  Thu Oct 15, 2009 18:17
Size:  1K
To:  "NETWORKER AT LISTSERV.TEMPLE DOT EDU" <NETWORKER AT LISTSERV.TEMPLE DOT 
EDU>

A few questions on port numbers for NMC?

The installation documentation says:

"For the web server port number, use the default port number (9000) or
use a custom port number. Valid port numbers are between 1024 and 49151.

For the Console server, use the default port number (9001) or use a
custom port number. Valid port numbers are between 1024 and 49151.
Note: Do not use port numbers already in use. Port 2638 is reserved by
the NetWorker Console software by using the Tabular Data Stream (TDS)
protocol to communicate with the database. Port 9002 is the preferred
port for EMC Backup Advisor product."

1. I thought I remember reading somewhere - maybe on this listing -
about some command to set ports that you're supposed to run before
installing NW on the server? Maybe that was something else entirely?

2. Do most folks use the defaults?

3. I assume the installation will prompt for these?

4. Best way to change these values later?

Thanks.

--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER



This e-mail may contain Sprint Nextel Company proprietary information intended 
for the sole use of the recipient(s). Any use by others is prohibited. If you 
are not the intended recipient, please contact the sender and delete all copies 
of the message.

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER