Re: [Networker] Networker 7.4.4 - monitoring clone sessions
2009-06-04 14:46:23
Len Philpot wrote:
Mark Davis
When running nsrclone on a list of savesets, and viewing the
Monitoring/Sessions tab, and with "Show: Clone Sessions", there is no
dynamic update showing the progress of the job. It simply shows the
total amount to be cloned and then does not update. When the job is
complete, the session disappears.
If I run nsrwatch, I do see the dynamic update of the job:
cloning session:19 of 59 save set(s) reading from VT600029 31 GB of 82
GB
servername:cloning session saving to pool 'vtl3clone' (VT600036)
Has anyone else noticed this? Is there a workaround?
If you can generate (or already know) a list of the ssids that are being
cloned, you can run mminfo against that list and watch the "copies" field.
Those with only one copy are not yet cloned. The totalsize (or sumsize)
field will also give you a rough idea of the relative time to clone them
based on their size.
I realize that's not a whole lot, but it's more than nwadmin/nsrwatch will
tell you. :-)
Actually, I was happy with the display in nwadmin (version 7.2.2).
nwadmin or nsrwatch at least provided a reasonable estimate of progress.
With the new 7.4 Administration GUI, I have no idea how far the job has
progressed. Your suggestion is a good one, but I was hoping to see a
better presentation in the GUI.
I have noticed that if I run nsrstage on savesets, the sessions window
does update dynamically. I should have mentioned that in my original post.
Thanks,
Mark
--
Mark Davis
NetWorker Support - I.T.S
University of Western Ontario
519-661-2111 x85504
email: davism AT uwo DOT ca
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|