Re: [Networker] tape ejection after upgrade of Networker
2009-04-13 09:43:42
Hello,
If you reinstall the Tape lib then all the parameters that were changed
from defaults will get reset back to defaults, check on ideal device
time-out
( need to turn on Diagnostic mode>view>diagnostic mode) before you see
them.
Thanks
kurianv <networker-forum AT BACKUPCENTRAL DOT COM>
Sent by: EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
04/13/2009 07:21 AM
Please respond to
NETWORKER AT LISTSERV.TEMPLE DOT EDU
To
NETWORKER AT LISTSERV.TEMPLE DOT EDU
cc
Subject
tape ejection after upgrade of Networker
Hi,
I had done an upgrade from Networker 7.2 to 7.4 on windows. The difference
I noticed is that , usually earlier in Networker 7.2 after some tape
operation like backup or recover after 10 minutes of no operation the tape
automatically got ejected. But now i notice that the tape does not get
automatically ejected.
Any suggestions for this ?
Regards,
kv
+----------------------------------------------------------------------
|This was sent by kurianji AT gmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
"signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|