The GUI now does a pretty passable job of doing the same thing. I now prefer
the GUI for editing a jb config.
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of Davina Treiber
Sent: Wednesday, February 18, 2009 3:30 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: Re: [Networker] jukebox reconfig question
Francis Swasey wrote:
> I'm going to be reconfiguring my jukebox next Monday and before I go
> and delete the jukebox and recreate it (and inventory 800 tapes) just
> to move a tape drive from one storage node to another, I'm hoping that
> jbedit will be my helpful helper here...
>
> I'm running 7.4.4, on a Solaris 9 nsrserverhost and several Red Hat
> Linux storage nodes. The jukebox robot is attached to the Solaris 9
> server and the 14 tape drives are spread across 7 storage nodes. The
> plan is to move drive 14 from rd=stornode1.uvm.edu:/dev/nst0 to
> rd=stornodeA.uvm.edu:/dev/nst0. The jukebox identifies this as
> element
> 40013 (via sjisn).
>
> Anyone fluent enough with jbedit to confirm that the following will work:
>
> jbedit -j 'Qualstar XLS' -E 40013 -d -f 'rd=stornode1.uvm.edu:/dev/nst0'
>
> jbedit -j 'Qualstar XLS' -E 40013 -a -f 'rd=stornodeA.uvm.edu:/dev/nst0'
>
> -- if it is -- I figure I should at least disable the jukebox in
> NetWorker while I'm doing this, but should I really (to be safe) shut
> NW down? Should I perform the delete, move the tape drive, and then
> perform the add? Or is that timing not relevant?
jbedit is pretty stable these days. Back in the 7.2 era I wouldn't have
trusted it but now it works. The only missing step is to recreate the tape
device in NetWorker, in between your two jbedit commands. jbedit -d removes
the tape drive from NetWorker whether you want to or not.
You can't shut NetWorker down to do this, jbedit requires NetWorker to be
running (fairly obviously). The timing of moving the drive is not too
important, except to have the drive in place before you define it in
NetWorker.
If you want to be paranoid, you could copy your res directory before you
start, to facilitate an easy rollback if it goes t-up. Not that I would
expect it to.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
"signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or via RSS at
http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
