Hello,
Inquire will do it, check the man page.
Check for entries such as
[email protected]:IBM ULTRIUM-TD1 022C|Tape, \\.\Tape9
Where Tape drive 9 is seen by Os on SCSI 4 ( the numbers correspond to
BUS\Target\Lun), If you had a reference to how they were before the repair
then you can tell if they changed or not, if they changed, you may need to
reconfigure your tape library, along with that a Full diagnostic of Tape
Lib should be conducted to rule out any lingering hardware issue.
HTH
[email protected]:ADIC Scalar i2000 4462|(Unknown Device Type c)
S/N: ADIC203101904
VENN=ADIC Scalar i2000
203101904
IENN=500308C001B5F809
IEPN=500308C001B5F80B
WWNN=500308C001B5F809
WWPN=500308C001B5F80B
PORT=00000002
[email protected]:IBM ULTRIUM-TD2 8571|Tape, \\.\Tape12
S/N: F001B5F025
ATNN=IBM ULTRIUM-TD2
F001B5F025
WWNN=500308C001B5F025
WWPN=500308C001B5F026
[email protected]:IBM ULTRIUM-TD2 8571|Tape, \\.\Tape13
S/N: F001B5F02B
ATNN=IBM ULTRIUM-TD2
F001B5F02B
WWNN=500308C001B5F02B
WWPN=500308C001B5F02C
[email protected]:ADIC Scalar i2000 4462|(Unknown Device Type c)
S/N: ADIC203101904
VENN=ADIC Scalar i2000
203101904
IENN=500308C001B5F802
IEPN=500308C001B5F803
WWNN=500308C001B5F802
WWPN=500308C001B5F803
PORT=00000001
[email protected]:ADIC Scalar i2000 571A|Autochanger (Jukebox),
\\.\Changer0
S/N: ADIC203101904_LL0
ATNN=ADIC 203101904_LL0
[email protected]:IBM ULTRIUM-TD2 8571|Tape, \\.\Tape10
S/N: F001B5F001
ATNN=IBM ULTRIUM-TD2
F001B5F001
WWNN=500308C001B5F001
WWPN=500308C001B5F002
[email protected]:IBM ULTRIUM-TD2 8571|Tape, \\.\Tape11
S/N: F001B5F007
ATNN=IBM ULTRIUM-TD2
F001B5F007
WWNN=500308C001B5F007
WWPN=500308C001B5F008
ee01akk <networker-forum AT BACKUPCENTRAL DOT COM>
Sent by: EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
01/22/2009 11:30 AM
Please respond to
NETWORKER AT LISTSERV.TEMPLE DOT EDU
To
NETWORKER AT LISTSERV.TEMPLE DOT EDU
cc
Subject
Jukebox Problem
Hi Fazil,
What commands can I run to check these?
Thanks.
Fazil Saiyed wrote:
> Hello,
> Did the control lun assignment changed, either your hardware is still
> having issues or the paths for the Lib & drive has changed.
> Thanks
>
>
>
> ee01akk <networker-forum < at > BACKUPCENTRAL.COM>
> Sent by: EMC NetWorker discussion <NETWORKER < at > LISTSERV.TEMPLE.EDU>
> 01/22/2009 11:09 AM
> Please respond to
> NETWORKER < at > LISTSERV.TEMPLE.EDU
>
>
> To
> NETWORKER < at > LISTSERV.TEMPLE.EDU
> cc
>
> Subject
> Jukebox Problem
>
>
>
>
>
>
> When configuring the jukebox from the jbconfig command, getting the
> following error:
>
> SJI Failure[0x 29]: Aborted Command, INITIATOR DETECTED ERROR Message
> Received
>
> Recently swapped out autoloader and drive due to hardware problems.
>
> Inquire output works fine.
>
> We get this error when asked if you want to delete the existing
definition
> after finding device \\.\Tape0 already configured in Networker.
>
> Any ideas on this error?
>
> +----------------------------------------------------------------------
> |This was sent by ee01akk < at > hotmail.com via Backup Central.
> |Forward SPAM to abuse < at > backupcentral.com.
> +----------------------------------------------------------------------
>
>
> "signoff networker" in the body of the email. Please write to
> networker-request < at > listserv.temple.edu if you have any problems
with this
> list. You can access the archives at
> http://listserv.temple.edu/archives/networker.html or
> via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
>
>
>
> via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
+----------------------------------------------------------------------
|This was sent by ee01akk AT hotmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
"signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
