Re: [Networker] The volid on tape and the one in media base is not the same!
2008-06-01 19:44:01
On Jun 1, 2008, at 3:23 PM, NetWorker wrote:
Most likely your device names are wrong in your jukebox config.
The easiest way to test if the device name is wrong in the jukebox
config:
1) Make sure both tape drives are empty.
2) Use 'nsrjb -l -n -f <device name> <volume name>' to load a tape
into one
of the drives without mounting. Again, make sure the other drive is
empty.
3) After it finishes do 'mt -f <device name> status' on both tape
drive
device names. (it mioght be 'mt -t' on AIX, I don't remember) See
which
device it really got loaded into.
I also suggest that Ramo make sure his tape drives are all actually
connected with a data cable properly and that the NetWorker can see
them. Physically inspecting the tape drives is the only way to do
that. I have seen that "no such device or address" error pop up when I
mistakenly forgot to plug in a tape drive's fiber channel cable after
I replaced a bad drive with a new one. Duh!
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|