|
Re: [Networker] The volid on tape and the one in media base is not the same!
2008-05-25 06:05:07
The way I do that is to have NetWorker mount a tape in a drive and then
go look on the system to see if it got mounted in the correct drive.
I know which drive it should be, and use the mt command to check if it
is in that drive. If it isn't, then I can either go look at the drives
to see where the tape did wind up, or I can run mt commands against the
rest of the drives until I find the one that has a tape that shouldn't
(This is always easier if NetWorker isn't playing with the jukebox at
the same time).
Frank
On 5/25/08 3:03 AM, ramo wrote:
thx Peter;
but how to check that my tape devices are setup in the wrong order or not ?
+----------------------------------------------------------------------
|This was sent by bob_omar_31 AT yahoo DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
--
Frank Swasey | http://www.uvm.edu/~fcs
Sr Systems Administrator | Always remember: You are UNIQUE,
University of Vermont | just like everyone else.
"I am not young enough to know everything." - Oscar Wilde (1854-1900)
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|
