|
Re: [Networker] NW Clone question on source and target drives
2008-04-04 15:00:12
I'm running 7.3.3 myself -- and I also have a similar problem, I
resorted to figuring out the first tape that was going to be needed and
mounting that in the drive I want before issuing the nsrclone command.
On 4/4/08 2:46 PM, Bruce Breidall wrote:
The nsrclone command is run on the NW server, which is where I want both
the read and write volumes mounted, yet I can't force this to happen.
-----Original Message-----
From: Francis Swasey [mailto:Frank.Swasey AT uvm DOT edu]
Sent: Friday, April 04, 2008 1:45 PM
To: EMC NetWorker discussion; Bruce Breidall
Subject: Re: [Networker] NW Clone question on source and target drives
What version of NW are you using? Is the nsrclone command being run on
the nsrserverhost or on the client? I believe the clone storage node of
the system where the nsrclone command is running is the one that matters
(if the source tape/device is not already mounted somewhere).
--
Frank Swasey | http://www.uvm.edu/~fcs
Sr Systems Administrator | Always remember: You are UNIQUE,
University of Vermont | just like everyone else.
"I am not young enough to know everything." - Oscar Wilde (1854-1900)
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|
