Use two % instead of one.
%%used=full

>>> George Sinclair <George.Sinclair AT NOAA DOT GOV> 7/31/2007 4:37:57 PM >>>
Is there a way I can specify not '%used=full' with mminfo?

I want to see all volumes in a particular pool that are still 
appendable. I know I can used '%used<=100', or I can pipe it to 
something like: grep -v  " full ". Just curious if  there was some way 
to use '!%used=full', but that doesn't work, nor does '%used!=full'.

George

-- 
George Sinclair - NOAA/NESDIS/National Oceanographic Data Center
SSMC3 4th Floor Rm 4145       | Voice: (301) 713-3284 x210
1315 East West Highway        | Fax:   (301) 713-3301
Silver Spring, MD 20910-3282  | Web Site:  http://www.nodc.noaa.gov/ 
- Any opinions expressed in this message are NOT those of the US Govt. - 

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER