Re: [Networker] permaturely gets full
2006-12-05 06:48:24
Just check you are not getting any I/O errors during the cloning. We
had issues where some dodgy fibre-scsi bridges would issue a I/O error
on all tape drives anytime a drive on the bridge ejected a tape.
Networker sees the I/O error, assumes it is a bad tape and marks it as
full and moves on.
Mokong Ako wrote:
Hi fellow networkers,
We are having a problem with our setup, we are using Networker 7.2.1 build
311 and L20 device. All seems ok with the routine backup, but when we
started doing cloning, most of the clone pools prematurely gets full. We
are using LT03 tapes and some fills only upto 25 GB. Is there a setting
somewhere that i might have missed ?
Thanks for your help.
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|