We're running Solaris 10 and v7.2.2. We can use the sji command
successfully.
We did, however, have issues when trying to configure the library
because inquire was suddenly gone when we upgraded from Solaris 9 to
Solaris 10. EMC support should be able to provide you with information
about configuring your library without inquire.
We found tech bulletin #420 at
http://softwaresupport.emc.com/wcmprodData/tech_papers/bulletins/420.htm
l to be very helpful. Based on a conversation with tech support,
however, we think there is a typo and that the "./mt" in step 3 should
be "./mtx".
I *think* I saw something about the sji commands going away in v7.3.x.
Can anyone confirm this? Anyway, the mtx commands appear to provide the
same functionality. Has anyone used these?
Thanks.
Teresa
-----Original Message-----
From: Legato NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
On Behalf Of Daryl Davis
Sent: Thursday, August 31, 2006 7:55 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Configuring SL500
The old way of configuring the library was to run "inquire" which
gives you the device path and the serial number of each drive. Then
we ran "sjisn b.t.l" (i think "sn -a b.t.l" would also work) which
gives each drive ELEMENT number and serial number. Then we could
match the serial numbers and figure out each device path and drive
element pair.
Next run "jbconfig" which is the script to manually configure the
Library (again the SL500 does NOT Auto-Configure via the 7.3 GUI).
jbconfig will ask "What is the device path to Drive 1 Element 500".
Using the information gained above, we used to be able to answer that
question.
Since Solaris 10, doesn't support the sji commands anymore,
the recommendation of the support engineer was to put a tape in one of
the drives and run "mt -f /dev/rmt/x status" on each /dev/rmt device
until finding the one with the tape. Although this does work, it
seems like a crappy solution. If it was possible to configure the
Library in Solaris <10 without physically touching the library, it
should still be possible. Right?
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
