Good morning to all,
Our backup setup it to save in the disk (d2d backup), then automatically clone
to tapes, but this weekend we had tape drive failure, thus the cloning to tape
didn't happen. There are some savesets in there which were already cloned prior
to tape drive failure, so I can't just clone the entire volume.
How can I clone the savesets in the disk backup device to tapes using a command
line? I can do it using the GUI, but it sure takes a lot of time to
choose/click all the savesets.
Environment: Networker server v7.1.4 on Red Hat ES 3
thanks in advance,
Librado Pamintuan
Technical Support Analyst II
Information Systems Dep.
Operations Group
City of Regina
Phone: (306) 777-7573
General Fax: (306) 777-6804
eFax: (306) 546-6002
eMail: lpamintuan AT regina DOT ca
<html><body><font face = "arial" size = "1">
DISCLAIMER: The information transmitted is intended only
for the addressee and may contain confidential,
proprietary and/or privileged material. Any
unauthorized review, distribution or other use
of or the taking of any action in reliance upon
this information is prohibited. If you received
this in error, please contact the sender and
delete or destroy this message and any copies.
</font><body></html>
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|