Re: [Networker] Couple of attempts run mminfo query and strange "RPC Failure: Can't decode result" error RE: mminfo results: with
2006-02-22 14:06:29
>
> Many thanks to those who responded with their ideas.
>
> I have tried to follow your suggestions and seems like each time I add
> 'level=full' to the query it stopped working (see couple of attempts
> below).
>
> Eventually I ran absolutely useless query, but have got funny result
> there :
> $
> $ mminfo -q 'level=full' -ot
> RPC Failure: Can't decode result
> RPC Failure: Can't decode result
> RPC Failure: Can't decode result
That doesn't look good. I can't guess if it implies database
corruption, but it also doesn't look like the odd quirk in 'mminfo'
output.
If you have support, I would open a case for this in case corruption is
involved.
> I tried to run the same mminfo command 2 other servers (both are also
> NetWorker 7.1.1 (build 277) on AIX) and did not get these error
> messages...
Are all the binaries (mminfo, nsrmmdbd) identical? I wonder if one of
them got a patch or something.
--
Darren Dunham ddunham AT taos DOT com
Senior Technical Consultant TAOS http://www.taos.com/
Got some Dr Pepper? San Francisco, CA bay area
< This line left intentionally blank to confuse you. >
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|