Re: [Networker] read errors during cloning
2005-11-22 03:57:07
If possible repeat the cloning and see if the errors are on the same spot,
possible put the source tapes in a different drive and repeat
just to isolate that its actually the tape that is bad and not a drive issue.
On Monday 21 November 2005 18:23, Pat DeCelie wrote:
> NetWorker Admins
>
> The environment:
> HP-UX 11i
> NW 7.1.3 w/Hotfix
> STK 9940B drives
> STK 9310 Silo with ACSLS
>
> We are getting read I/O errors during clone operations from the source
> tape. The data was backed up successfully and there are no suspect save
> sets. The drives look OK. The tape media looks OK as well. Has anyone seen
> this? Any suggestions are appreciated.
>
> Thanks,
> Pat
>
> To sign off this list, send email to listserv AT listserv.temple DOT edu and
> type
> "signoff networker" in the body of the email. Please write to
> networker-request AT listserv.temple DOT edu if you have any problems wit this
> list. You can access the archives at
> http://listserv.temple.edu/archives/networker.html or via RSS at
> http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
--
Maarten Boot,
Compuware Europe B.V.
Hoogoorddreef 5
1101 BA Amsterdam
Tel: +31 20 312 6511
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|