[Networker] Tape config for STKL180 on Solaris over fibre
2005-06-20 11:39:28
We have had our StorageTek L180 connected via fibre to our NetApps only.
The robotics have been in a separate fibre zone with our Sun Sparc box
that runs Legato. We are adding two drives and will be zoned with the
Sun. What st.conf entries do I need for the IBM Gen2 LTO drives and do I
need any special settings in the Emulex lpfc.conf?
----
Matthew Huff | One Manhattanville Rd
Director of Operations | Purchase, NY 10577
OTA LLC | Phone: 914-460-4039
http://www.otaotr.com | Fax: 914-460-4139
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Networker] Tape config for STKL180 on Solaris over fibre,
Matthew Huff <=
|
|
|