Re: [Networker] How to view CAP door contents?
2005-06-17 12:14:03
The sjirdtag binary works just dandy. A bit effusive, but the
information is all there. Found at least one shell script on google that
apparently makes sense of all the output, but I found the output to be
logical enough. Again, though, appears that only root users can run
these binaries. Non-root user attempts to run:
./sjirdtg scsidev@#.#.#
and gets error:
scsidev@#.#.#: No such device
Guess this is another case for setting up sudo.
George
Davina Treiber wrote:
George Sinclair wrote:
Is there any way to view the contents of a (C)atridge (A)ccess (P)ort?
We have a Storagetek L80tape library with a CAP door that has 5 slots.
If I had some tapes in there, I could look on the library gui panel and
see the names of the tapes if they had bar codes, but if I'm not at the
library, is there a way I can do this remotely via NetWorker? Didn't see
any options in nsrjb to do this. '-C' only shows contents of regular
operation slots, not CAP.
Not from within NetWorker itself, but of course sjirdtag can do it,
assuming your tapes are barcoded.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|