I just attached a jukebox to a Netapp (running 6.4.3).  The Master
Linux box is running 7.2.

Everything went pretty well.  Jukebox is controllable, the initial full
backup seemed to go fine.  However while testing a restore, I got
this...

  Performing recover from NDMP type of device
  Opened the tape device : nrst1a
  Performing non-DAR Recovery..

Hmm.  I want DAR here.  So I went through the manual again and realized
that I had left the DIRECT=y off the client.  Now the client looks like
this...  (it had the HIST and UPDATE already set during the backup).


            backup command: nsrndmp_save -T dump;
                      ndmp: Yes;
  application information : HIST=y, UPDATE=y, DIRECT=y;

However, that change didn't seem to allow me to perform a DAR recovery.
I have indexes for the backup.  Is there anything else I need to have in
place so that I can have DAR kick in for the recovery?

-- 
Darren Dunham                                           ddunham AT taos DOT com
Senior Technical Consultant         TAOS            http://www.taos.com/
Got some Dr Pepper?                           San Francisco, CA bay area
         < This line left intentionally blank to confuse you. >

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=