|
Re: [Networker] New Linux Legato Install
2005-06-02 16:13:39
Stewart, Kathy wrote:
We have two new Linux servers that we are adding to our Legato configuration.
We have a Scalar i2000 with 10 LTO2 drives (2 of which are new to the scalar).
Linux reports that it can see all 10 drives. The Legato inquire command sees 7 drives and times out on the other 3. Legato knowledgebase says that the Linux configuration is incorrect. Has anyone seen this error?
For those last 3 drives can you access them from Linux outside of
Networker? Try putting a tape in the drive and using the mt command for
example or actually sending some data to the tape with tar.
If Linux can manipulate the drive/tape then chances are it's not a base
OS problem.
--
Scott Russell <lnxgeek AT us.ibm DOT com>
IBM Linux Technology Center System Admin
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|
