That tape may be bad, probably getting stucked.
An Hardware reset would eject such tape
nsrjb -EH -f  <devicename>
Always run nsrjb -EI to run inventory otherwise the drive may be
unuseable

Akin

-----Original Message-----
From: Legato NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
On Behalf Of Andrew Bridgeman
Sent: Wednesday, June 01, 2005 10:37 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Tape0 gone into service mode.


I have just put 26 new tapes into my Tape Library but ever since this
has
been done Tape 0 has gone into service mode and when i do a full
inventory
of all 26 slots tape 12 comes up with erors like:

moving tape_bsf failed uknown error 1104 (0x450) (26843656)

The obvious thing to do is to try a different tape which is what i am
going
to do now and also use a cleaning tape in the drive, however the drive
is
only a month old so i do not see why this should need to be done
already.

Once i have done this how to up the threshhold of my maximum error
value?
and also how do i get the tape drive back to normal mode not service
mode?

Regards

Andrew Bridgeman

--
Note: To sign off this list, send a "signoff networker" command via
email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=