I am new to Networker and I have the following two tasks that need to be
done via the command line. I have been through mminfo, nsrjb, etc. and
though I get some of the information I cannot get it all. Can anyone assist
with this?
#1 Last night's backup run - what was successful and what
failed/errored/did not complete successfully
I used "mminfo -a -t 'yesterday' -r 'client,pool,name,nfiles,totalsize' but
I am not sure if I am seeing failed/errored/did not complete successfully
#2 For all successful backups I need the following information:
client, group, number of files, size of what was backed up, start time,
finishe time, kb/minute backed up.
Again I can get most of this with the mminfo command but I cannot get start
time, stop time, kb/minute backed up. If I could get start&stop time I
could canculate the kb/minute.
regards
Dan Sanville
Dan.Sanville AT inforonics DOT com
Networker Version 6.1.1 running on Solaris 2.8
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|