Hi Guys,

Just a quick question as I have just second guessed myself, and when I
asked a few peers they were also under the same assumption as I...

I was always in the belief that before we upgraded our Tru64 Networker
servers to v7.1.2, they need to be running tru64 v5.0B or higher
(ie. v5.1B).......but today whilst completing an excel spreadsheet report,
I decided to have a quick check in the v7.1 tru64 installation guide and
was a little surprised to see "Tru64 v4.0F or Later..." listed for Client,
Storage node, and Also Server........

Has anyone installed and ran v7.1.2 on a Tru64 v4.0F systems without any
issues ??? or is the install guide throwing me a huge Furfy ???

2 months ago I extracted this from aLegato Document..
======================================
 Networker V7 supports the following:
Tru64 v5.0A, v5.1, v5.1A, v5.1B
SunOs   v7, v8, v8  (both 32 & 64 bit)
AIX 5L v5.1, 5L v5.2
Hpux 10.20, 11.00, 11.11, 11i 1.5 & 1.6
======================================

Craig.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=