Networker

Re: [Networker] Legato 6.1.3 and L8

2004-01-21 16:24:47
Subject: Re: [Networker] Legato 6.1.3 and L8
From: "Ungaro, Matt" <mjungaro AT CAPITOLINDEMNITY DOT COM>
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Date: Wed, 21 Jan 2004 15:02:59 -0600
Did /dev/rmt entries get created? And is the loader/drive in your
/etc/path_to_inst? prtconf -pv will give you a good hardware list and the
ability to see if at least the OS sees the drives.

-----Original Message-----
From: Mariusz Bogumil [mailto:marbo AT tpi DOT pl]
Sent: Wednesday, January 21, 2004 2:50 PM
To: Legato NetWorker discussion; Ungaro, Matt
Subject: Re: [Networker] Legato 6.1.3 and L8
Importance: High





>hat are the SCSI IDs of your L8? You need to make sure that if they are
very
>igh (Above 7) that you have them set up in the /kernel/drv/st.conf file.
>hen the OS can see them. Also, when you add new hardware (And please don't
>e offended, this is just my tech support schpiel) you need to make sure you
>o a reconfigure boot, even if it's something as simple as a disk or tape
>rive.
below 7 ( 3 drive and 5 library) Sol8 and newest st and glm patches
with boot -r and nothing

mb

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

<Prev in Thread] Current Thread [Next in Thread>