AND IF IT DOESN'T WORK DON'T BE AFRAID TO  OPEN THE JUKEBOX
AND RESET MANUALY THAT DRIVE WITH THE LAST TAPE IT USED IN IT!
AND THEN "UNMOUNT" BY THE GUI
----- Original Message -----
From: "Stan Horwitz" <stan AT TEMPLE DOT EDU>
To: <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>
Sent: Monday, August 11, 2003 11:53 AM
Subject: Re: [Networker] NSR sees a tape, which isn´t there


On Mon, 11 Aug 2003, Gross Nikolaus wrote:

>Hi,
>
>is there a possibility to unmount a drive with sun solaris 8.
>I have a Storagetek L700 and and NSR 6.1.3.
>when I perform a nsrjb -H(E) it doesn´t react.

>In horizon I can see that the tape isn´t in the drive, with NSR it is in
>a drive.

If the tape NSR thinks is in the drive is available, put it in the drive,
then run "nsrjb -C" to make sure the slot NSR thinks it came from is also
empty (assuming you're using a jukebox). Then run "nsrjb -HE"  again. This
should clear up the problem.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=


--------------------------------------------------------------------
CONFIDENTIALITY NOTICE
This message and its attachments are addressed solely to the persons
above and may contain confidential information. If you have received
the message in error, be informed that any use of the content hereof
is prohibited. Please return it immediately to the sender and delete
the message. Should you have any questions, please contact us by
replying to webmaster AT telecomitalia DOT it.
        Thank you
                                        www.telecomitalia.it
--------------------------------------------------------------------

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=