But don't forget the sleep timer bug (STL only).

If you happen to use an STL (ACSLS, etc) then you should also set the
barcode flag in the jukebox resource. Some releases of Networker ignore the
sleep timer if no flags have been selected.

Bye
Ernie


-----Original Message-----
From: Davina Treiber [mailto:treiber AT HOTPOP DOT COM]
Sent: Monday, June 23, 2003 4:53 PM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: Re: [Networker] DLT 7000 drives keep having tape leader
problems


On Tue, 17 Jun 2003 17:56:57 +0200, Bokkelkamp Ernst
<ernst.bokkelkamp AT SIEMENS DOT COM> wrote:

>And another fix is to have STK check the firmware of the library and the
>tape drives. There used to be a bad fw revision giving this problem, the fw
>fixes this by inserting a delay between operating the handle and removing
>the tape.

Always worth having up to date firmware, but you could also consider
increasing the "unload sleep" and "eject sleep" attributes of the NSR
jukebox resource. The defaults are usually too low for DLT 7000 drives.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=