Hi Dave,
I tried it and it still loads each previously labled tape into the drives.
Regards,
/\/elson
On Wed, 28 May 2003, Dave Werth wrote:
> I think by using the -E parameter you basically force Networker to verify
> each tape by reading its tape label. Try it with just -Iv.
>
> David Werth
> UPS Aviation Technologies
> (formerly: II Morrow)
> Salem, Oregon
> iim1dfw AT at.ups DOT com
>
> -----Original Message-----
> From: David E. Nelson [mailto:david.nelson AT ni DOT com]
> Sent: Wednesday, May 28, 2003 1:47 PM
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] Bypassing library inventory when added volumes via the
> CAP
>
> Hi All,
>
> We've got an L180, 6.1.3, and Solaris 8. All tapes are barcoded and the
> tape
> label == barcode. When we add tapes via the CAP, we have to do 'nsrjb -j
> L180-1 -IEv' to re-inventory the slot that were just filled. Is there any
> way
> around this so that NW can just use the barcodes and not have to physically
> load/unload each tape that was added via the CAP?
>
> Thanks,
> /\/elson
>
> --
> ~~ ** ~~ If you didn't learn anything when you broke it the 1st ~~ ** ~~
> time, then break it again.
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
--
~~ ** ~~ If you didn't learn anything when you broke it the 1st ~~ ** ~~
time, then break it again.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|