Re: [Networker] L20 and Networker 6.1.3
2003-05-09 13:31:57
On Fri, 9 May 2003 13:18:15 -0400, Howard Martin <howard.martin AT EDS DOT COM>
wrote:
>I've had no problems detecting a L20 - 6.1.3 uses jbconfig not jb_config.
Yes, sure jbconfig...
>Simplest things first
>Have you rebooted with the -r flag?
>Do you have /dev/rmt entries corresponding to the tape drives ?
>Does prtdiag see your SCSI bus?
Unfortunately i don't see either /dev/rmt entries and SCSI bus, even
after a reconfigure boot.
>
>if you don't see the tape drive - check the cabling and termination, if you
>are using LVD SCSI and there was a problem when setting it up (in my case I
>used the wrong terminator) I've found it essential to powercyle the Sun.
>If the drive and the robot arm are on the same SCSI bus adn you can see the
>drive but not the robot then it looks like a hardware call to storagetek.
>
>On Fri, 9 May 2003 12:15:07 -0400, Antonio Ettorre
><antonio.ettorre AT ERPTECH DOT IT> wrote:
>
>>Hi to everyone,
>> My system is Sun-Fire-280R with Solaris 8 and Networker
>>6.1.3.Build.428, we install a new Tape library on the system: one STK L20
>>that is attached by a SCSI card on PCI bus of system.
>> Unfortunaly either jb_config and inquire don't find any SCSI jukeboxes
>>attached to this system.
>>Someone have my same problem and solve it?
>>
>>--
>>Note: To sign off this list, send a "signoff networker" command via email
>>to listserv AT listmail.temple DOT edu or visit the list's Web site at
>>http://listmail.temple.edu/archives/networker.html where you can
>>also view and post messages to the list.
>>=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
>--
>Note: To sign off this list, send a "signoff networker" command via email
>to listserv AT listmail.temple DOT edu or visit the list's Web site at
>http://listmail.temple.edu/archives/networker.html where you can
>also view and post messages to the list.
>=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|