Hi, I have configured a HP-UX 11 box to connect to a Tape SAN. The fibre
card has been installled and after a reboot it can see the tape devices and
robot.
The problem is that it picks up the robot and each tape device 16 times. There
should be three tape devices and one robot. It seems to pick it up from the
fibre card on 16 targets. From 0-15. This is seen through ioscan.
Using SAM the tape devices have been added to the system but again, it has
added 3*16 devices and created the appropriate file names in /dev
How can I correct this? Should I be looking at configuration of the Fibre card
that I am using. The model of the FC-HBA is HP A6795A and is using the latest
driver from the HP web site with appropriate HP patching.
Thanks again,, Mark
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|