I don't know the settings for DLT7000, I have STK 9940 and I have changed the 
st.conf. But what you have certainly to do is to define in lpfc.conf persistent 
bindings for your tapes. 

Regards.
Pierre.


-----Original Message-----
From: Mark T Wragge [mailto:storage AT TTT DOT IE] 
Sent: dinsdag 15 april 2003 15:20
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: No devices in /dev/rmt


Networker 6.1.3
W2k Networker Server (QLogic HBA)
Solaris 2.8 SAN Storage Node  (Emulex HBA)
DLT7000 * 3
ADIC 100 Library

Windows Server can see all three drives and I have used Jbconfig to install and 
test. A Solaris issued ./inquire command can see robot and drives but the 
drives are not named (i.e. no /dev/rmt/0cbn).  When I go to /dev/rmt it is 
empty.
I have run: reboot -- -r   drvconfig  tapes

Am I required to edit the st.conf file on Solaris 2.8?
If so, exectly what do I have to do?  There are two entries related to DLT7000 
and I have removed the # from the front of them and inserted  ; at the end of 
each entry.

Would I need to reboot after editing the st.conf file.
Do you think I am on the right track to troubleshooting the problem?


Thanks in advance, Mark




--
Note: To sign off this list, send a "signoff networker" command via email to 
listserv AT listmail.temple DOT edu or visit the list's Web site at 
http://listmail.temple.edu/archives/networker.html where you can also view and 
post messages to the list. 
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=