Re: [Networker] Labelling Used Tapes
2002-10-31 08:45:04
Simon,
You can label them fromt the command line and use the -Y flag. Hopefully the
tape number are sequential and you can use
a range.
Regards,
Guy Novello
-----Original Message-----
From: Simon Phillips [mailto:sdph AT DML.AC DOT UK]
Sent: Thursday, October 31, 2002 4:30 AM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Labelling Used Tapes
Hi,
I need to relabel 160 used tapes. If I use the admin screen, I have to go
through each tape individually answering "YES" to the "Are you sure" prompt. Is
there a command to relabel the lot (using bar codes) without user intervention?
Thanks
Simon Philllips
System Administrator/DBA
UHI Millennium Institute
Dunstaffnage Marine Laboratory
Dunbeg, Oban, Argyll
PA37 1QA
Tel: +44 (0) 1631 559286
Mobile: 07885-663308
Fax: 01631 559001
Email: s.phillips AT dml.ac DOT uk
http://www.uhi.ac.uk
--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|