Re: [Networker] Help!!!!
2002-10-21 09:11:44
Hi, Bob ,Thank you for your message.
I have no configure any zoning on the FC switch .
I am afraid that if my st.conf file under the /kernel/drv/ directory is not
correct .
did any one can mail me a correct example to me with the similar environment .
Thanks in advance .
Thanks again
Eric
----- Original Message -----
From: Wood, R A (Bob) <WoodR AT ChevronTexaco DOT com>
To: 'Legato NetWorker discussion' <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>;
'Legato_Networker' <Legato_Networker AT 163 DOT COM>
Sent: Monday, October 21, 2002 8:23 PM
Subject: RE: [Networker] Help!!!!
> Is zoning active in the switch?
>
> -----Original Message-----
> From: Legato_Networker [mailto:Legato_Networker AT 163 DOT COM]
> Sent: 21 October 2002 12:24
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] Help!!!!
>
> Hello , all
>
> Environment :
>
> Host: Sun 280R + solaris 8
> HBA card: Qlogic 2200
> FC switch : brocade 2800
> Tape Library : ADIC scalar 1000 + 2 LTO driver + SNC 5000
> Disk Arrary : HDS
>
>
>
> Problem :
>
> I can see the HDS' disks ,but I can not see the tape library's drivers and
> robot.
> from the /var/adm/messages , I can not see the IBM LTO driver
>
> Does any one can give me a hand ?
>
> Thanks a lot
>
>
>
>
>
>
>
>
|
|
|