Did you read the comments in 'chg-zd-mtx'?
Make sure you can successfully complete the basic test procedures written in
'chg-zd-mtx'
-----Original Message-----
From: Jesus Salvo Jr. [mailto:jesus.salvo AT communicator.com DOT au]
Sent: Monday, April 11, 2005 2:07 AM
To: amanda-users AT amanda DOT org
Subject: Newbie: amlabel: could not load slot "current": changerfile
must be specified in amanda.conf
Hi,
I have a StorEdge L7 on an E220R running Solaris9.
I have configured Solaris9 with sgen and mtx and chg-zd-mtx
mtx is working
chg-zd-mtx is also working
The relevant entries in amanda.conf are:
changerdev "/dev/scsi/changer/c2t1d0"
tpchanger "chg-zd-mtx" # the tape-changer glue script
tapedev "/dev/rmt/1n" # the no-rewind tape device to be used
changerfile "/usr/local/etc/amanda/Daily/chg-zd-mtx"
tapetype DLT8000
The conf file for chg-zd-mtx is:
/usr/local/etc/amanda/Daily/chg-zd-mtx.conf
Note that the changerfile entry in amanda.conf does not have the ".conf"
suffix, as per the document in the chg-zd-mtx script ... and it is the only
way to get chg-zd-mtx working.
However, when I do amlabel, I get:
$ amlabel Daily Daily001
amlabel: could not load slot "current": changerfile must be specified in
amanda.conf
Regards,
John
|