Another MTX Question:
2003-08-06 16:32:01
OK this is simple stuff, right?
My chg-zd-mtx config file shows:
havereader=1
BUT
Following the instructions in the chg-zd-mtx.config file I am testing, and do :
* Run this:
#
# .../chg-zd-mtx -info
# echo $? #### (or "echo $status" if you use csh/tcsh)
I do this:
sh chg-zd-mtx -info
and I get
1 79 1 <--missing 4th # here!
(btw, what is the triple ... refer to? it's been a LONG time since I was in
class...(;>) **
# The fourth number is optional. If you set $havereader to 1, it
# will be "1", otherwise it will not be present.
#
(and next step isn't good either...
sh chg-zd-mtx -reset
Bus Error(coredump)
echo $?
138
** when I tried without the sh in front of command, it just closed the existing
window, and couldn't read the results.
--chg-zd-mtx.conf follows:
# Last change 8/6 3:50PM Changed driveslot from 1 to 0, removed extra line in
definition
# changerdev /dev/scsi/changer/c1t0d0 # NOT in Roli's file
firstslot=0 #### First storage slot (element) -- required
lastslot=81 #### Last storage slot (element) -- required
cleanslot=0 #### Slot with cleaner tape -- default is "-1"
autoclean=0 #### Set to '1' or greater to enable
autocleancount=99 #### Number of access before a clean.
#havereader=1 #### If you have a barcode reader, set to 1.
havereader=1
offline_before_unload=1 #### Does your robot require an mt offline?
poll_drive_ready=05 #### Time (seconds) between tests to see if drive
ready
max_drive_wait=99 #### Maximum time (seconds) to wait for the
unloadpause=6 #### delay between unloading and putting tape back
driveslot=0 #### Drive slot number. Defaults to the
.. my amanda.conf snippet here:
################################################
# this is from amanda.conf modified for chg-zd-mtx
#
################################################
changerdev "/dev/scsi/changer/c1t0d0"
tpchanger "chg-zd-mtx" # the tape-changer glue script
tapedev "/dev/rmt/0n" # the no-rewind tape device to be used
# note (mb) the 1 refers to config # 1 within scsi.conf
changerfile "/usr/local/etc/amanda/DailySet1/chg-zd-mtx.conf"
#changerfile "/usr/local/etc/amanda/DailySet1/chg-scsi.conf"
I think that's it..
And to think Yesterday, it worked, and today...ugh
Mitch
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Another MTX Question:,
Bruntel, Mitchell L <=
|
|
|