Jonathan B. Bayer wrote:
I'm just configuring Amanda to work with our tape libraries. For some
specific volumes I want to always do a full dump. According to the
manual page, the "strategy noinc" should do it. However, in the example
amanda.conf, it specifically says that "Unfortunately, this is not
currently implemented. Use `dumpcycle 0' instead."
Is this option available? I'd like to use it instead of the dumpcycle 0
option.
Any reason why? "dumpcycle 0" can be an option on a specific dumptype,
just like "strategy noinc" would have been. It overrides the global
dumpcycle for that particular dumptype.
Probably nobody implemented "strategy noinc" because of this.
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|