amflush won't work, amstatus 0%
2003-06-19 08:31:28
I can't flush data and amstatus reports 0% data.
I got a server that someone forgot to load the tapes in.
So, the holding disk growed to 100%. Then I came to make
some flushing of the data. There are a lot of days
waiting to be flushed. One of them I thought it didn't
fit in the tape, so I wanted to skip it and try to flush
it later.
There were [A..P], and I typed this: B C D and so on
But when I check the amstatus it displays like this:
Using /var/lib/amanda/Daily/amflush
SUMMARY part real estimated
size size
partition : 0
estimated : 0 0k
flush : 0 0k
failed : 0 0k ( 0.00%)
wait for dumping: 0 0k ( 0.00%)
dumping to tape : 0 0k ( 0.00%)
dumping : 0 0k 0k ( 0.00%) ( 0.00%)
dumped : 0 0k 0k ( 0.00%) ( 0.00%)
wait for writing: 0 0k 0k ( 0.00%) ( 0.00%)
wait to flush : 0 0k 0k (100.00%) ( 0.00%)
writing to tape : 0 0k 0k ( 0.00%) ( 0.00%)
failed to tape : 0 0k 0k ( 0.00%) ( 0.00%)
taped : 0 0k 0k ( 0.00%) ( 0.00%)
all dumpers active
taper idle
That wasn't the usual status flushing report at all.
I stopped it, run amclear and tried again. Now I only
asked it to flush one day.
It happens the same.
How can I clean this mess ? Thank you .
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- amflush won't work, amstatus 0%,
Francesc Guasch <=
|
|
|