Hello,
i'm currently stuck. I cant do any backup, amcheck says it's not an amanda
tape. I tried to label the tape but amlabel says that the label is already on
the tape. So i did a amrmtape. Now i'm having trouble labelling the tape
again. These tapes have been used before for amanda.. abt six mths ago, so
now i'm doing a new installation, that's why the labels are still there.
This is my "dmesg"
blk: queue f7e16e18, I/O limit 4095Mb (mask 0xffffffff)
Vendor: BNCHMARK Model: DLT1 Rev: 5032
Type: Sequential-Access ANSI SCSI revision: 02
blk: queue c8eaa218, I/O limit 4095Mb (mask 0xffffffff)
(scsi0:A:5): 20.000MB/s transfers (10.000MHz, offset 15, 16bit)
Attached scsi tape st0 at scsi0, channel 0, id 5, lun 0
My tapetype.
define tapetype daily {
comment "just produced by tapetype program"
length 34798 mbytes
filemark 152 kbytes
speed 2578 kbytes
}
amanda@luke amanda $ amcheck tuesday
Amanda Tape Server Host Check
-----------------------------
Holding disk /backup: 9092960 KB disk space available, that's plenty
ERROR: /dev/nst0: not an amanda tape
(expecting a new tape)
NOTE: skipping tape-writable test
Server check took 5.045 seconds
Amanda Backup Client Hosts Check
--------------------------------
Client check: 1 host checked in 0.226 seconds, 0 problems found
(brought to you by Amanda 2.4.4)
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
amanda@luke amanda $ amlabel tuesday tuesday2
amlabel: label tuesday2 already on a tape
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
amanda@luke tuesday $ amrmtape tuesday tuesday2
amrmtape: preserving original database in curinfo.orig.28037 (exported).
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
amanda@luke tuesday $ amlabel tuesday tuesday2
rewinding, reading label, not an amanda tape
rewinding, writing label tuesday2, checking label
amlabel: no label found, are you sure /dev/nst0 is non-rewinding?
|