If you have mtx (from  sourceforge.net) on the system you can use:
mtx load slotnumber drivenumber
where 'slotnumber' is the number of the slot to get the tape from and
'drivenumber' is the tape drive number (probably 0 if you only have one drive).

Frank

--On Wednesday, December 18, 2002 18:32:56 -0500 "Jozwiak, Paul" <pjozwiak AT 
websitepros DOT com> wrote:

I have a SUNE150 with a Spectralogic 10000 40 slot tape array attached.
Does any know of a way to mount the one of the drives from the command on
the server remotely.

Paul D Jozwiak
WebsitePros, Inc. (Software Systems Analyst)
pjozwiak AT websitepros DOT com
W 904.680.6602
C  904.219.4981



------------------------ NOTICE ------------------------
This email message is for the sole use of the intended recipient(s) and may
contain confidential and privileged information.  Any unauthorized review,
use, disclosure or distribution is prohibited.  If you are not the intended
recipient, please contact the sender by reply email and destroy all copies
of the original message.
Any opinions expressed in this email are those of the individual and not
necessarily those of the company.
All liability for viruses is excluded to the fullest extent permitted by
law.

--
Frank Smith                                             fsmith AT hoovers DOT 
com
Systems Administrator                                  Voice: 512-374-4673
Hoover's Online                                          Fax: 512-374-4501