Hi Jennifer,

Do you have client-side compression enabled? I'm not familiar with what
the GUI reports, but dsmc will show this in the "Objects compressed by"
line.

On 11/03/2017 02:06 PM, Drammeh, Jennifer C wrote:
> I use collocation and I have a node where the System Admin has requested that 
> his data from a particular node be isolated on tapes by itself. I created a 
> collocation group and have associated this one node with the new group. This 
> node had previously been backing up to a different collocation group. I 
> created a new Policy Domain and associated the node with it as well. This 
> policy domain is set to send the data direct to tape instead of going to our 
> diskpool. I also modified the settings on the server to allow this system to 
> have 2 mount points.
>
> I had the SA launch a "full" manual backup from the GUI - using the "Always 
> Backup" option. Here are the problems I am seeing.
>
>
> 1.       I can see that the system state data when to a tape that was already 
> used by other nodes (which tells me the collocation is not working)
>
> 2.       It only mounted 1 tape in a drive while performing the backup
>
> 3.       The metrics at the end showed that it inspected 283 GB of data and 
> only transferred 175 GB which means it did not actually perform a full backup.
>
> Any ideas to help get a FULL backup of this data alone on a single 1 or 2 
> tapes and ideally using multiple tape drives to speed things up? (for backup 
> and restore)
>
> Thanks!
>
>
> Jennifer


--
-- Skylar Thompson (skylar2 AT u.washington DOT edu)
-- Genome Sciences Department, System Administrator
-- Foege Building S046, (206)-685-7354