Anyone install 6.3.6.00 server (mine is Linux) and experience any issues,
in particular with expiration?

I upgrade one server on Tuesday, from 6.3.5.100 due to issues with
replication that are address in 6.3.6.000.  Wednesday evening I started
getting alerts about the active log >80%.  At this point, expiration had
been running for 30+ hours (it normally finishes in an hour or so).

Fortunately, a DB backup cleared most of the log but expiration refuses to
stop.  Tried both 'cancel expiration' and 'cancel proc'.  It acknowledged
the cancel but wouldn't die.

This morning I was alerted the log >80 percent and a DB backup wouldn't
clear things and the expiration was still hung. I had to bounce the server.

Expiration kicked off after I bounced the server today and is still running
saying it has only processed 2-nodes after 3+ hours.  I hesitate attempting
to cancel it until further diagnostics can be performed.

I was going to upgrade all my servers to 6.3.6.000 but am holding off due
to this situation.

Any thoughts/suggestions?



--
*Zoltan Forray*
TSM Software & Hardware Administrator
Xymon Monitor Administrator
VMware Administrator (in training)
Virginia Commonwealth University
UCC/Office of Technology Services
www.ucc.vcu.edu
zforray AT vcu DOT edu - 804-828-4807
Don't be a phishing victim - VCU and other reputable organizations will
never use email to request that you reply with your password, social
security number or confidential personal information. For more details
visit http://infosecurity.vcu.edu/phishing.html