Op 9 mei 2014, om 16:19 heeft Robert Ouzen <rouzen AT UNIV.HAIFA.AC DOT IL> het 
volgende geschreven:

> Hello
> 
> I tried to run command  of a Tsm server2 from a script on Tsm server1 without 
> success.
> 
> I create on tsm server 1 a servergroup as:   define servergroup tsm2
>                                                                               
>         Define grpmember tsm2 tsmserver2
> 
> My test script is like:  tsm2:q se
> 
> Launch the script on Tsm sever1 as:      run test
> 
> But got the q session of Tsm server1 instead the q session of Tsm server2
> 
> From the commandline of Tsm server1 of course is running fine.
> 
> It is possible or thru a script not at all ?


(tsm2) q se

if command routing from within a script iirc.

-- 

 Met vriendelijke groeten/Kind Regards,

Remco Post
r.post AT plcs DOT nl
+31 6 248 21 622