checkin libvol [libraryname] search=bulk status=scratch checklabel=barcode

unless the tapes are brand new and never been electronically labeled before,
then try:

label libvol [libraryname] search=bulk checkin=scratch labelsource=barcode

regards,

Paul


On Wed, Jul 20, 2011 at 8:23 PM, Paul_Dudley <pdudley AT anl.com DOT au> wrote:

> We have an IBM TS3200 tape library, which takes both LTO4 & LTO3 tapes. The
> I/O cartridge has capacity to slot in 3 tapes at a time. However I am not
> sure what is the correct command to check in 3 scratch tapes at the one time
> and get the tape library to search the I/O cartridge for each of the 3
> scratch tapes. Can someone advise me on the correct syntax of the checkin
> command for this?
>
>
>
>
>
> Thanks & Regards
>
> Paul
>
>
>
> Paul Dudley
>
> Senior IT Systems Administrator
>
> ANL Container Line Pty Limited
>
> Email:  <mailto:pdudley AT anl.com DOT au> pdudley AT anl.com DOT au
>
>
>
>
>
>
>
>
> ANL DISCLAIMER
>
> This e-mail and any file attached is confidential, and intended solely to
> the named addressees. Any unauthorised dissemination or use is strictly
> prohibited. If you received this e-mail in error, please immediately notify
> the sender by return e-mail from your system. Please do not copy, use or
> make reference to it for any purpose, or disclose its contents to any
> person.
>