I have installed 6.2 on AIX 6.1 in the last few days, fine onto two
difference servers, I haven't seen that issue. Have you had anything
useful back from IBM??
Jane Baker
AIX Technical Specialist
AIX/BASIS TEAM
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT vm.marist DOT edu] On Behalf Of
Robert Clark
Sent: 19 June 2010 02:04
To: ADSM-L AT vm.marist DOT edu
Subject: Re: [ADSM-L] TSM 6.2 server AIX installation issue
This is a "Friday afternoon, just about to go home" guess:
If your AIX box doesn't have the X11 libraries installed, (for example
if
it is headless), you may need SWING, which needs AWT, which comes in one
of the X11 filesets.
If installing X11 filesets resolves the issue, then the install doc
would
likely need to be revised to include "X11 filesets must be installed".
Thanks,
[RC]
From:
Pawlos Gizaw <Pawlos.Gizaw AT SANOFI-AVENTIS DOT COM>
To:
ADSM-L AT VM.MARIST DOT EDU
Date:
06/17/2010 07:03 AM
Subject:
[ADSM-L] TSM 6.2 server AIX installation issue
Sent by:
"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
Has anyone tried to install TSM 6.2 on AIX (6.1). I keep getting an
error
message that "Content is not allowed in prolog". I tried silent and
wizard
but got same message. The systems has all the minimum requirements.
Thu Jun 17 00:51:33.448 EDT 2010 : FINEST : User interface type:SWING
(from com.ibm.ac.coi.ext.ia.plugin.COIProcessInventorySteps.install)
Thu Jun 17 00:51:46.063 EDT 2010 : SEVERE : Aborting installer: Content
is not allowed in prolog. (from
com.ibm.ac.coi.ext.ia.plugin.COIProcessInventorySteps.install).
Thanks
Pawlos
U.S. BANCORP made the following annotations
---------------------------------------------------------------------
Electronic Privacy Notice. This e-mail, and any attachments, contains
information that is, or may be, covered by electronic communications
privacy laws, and is also confidential and proprietary in nature. If you
are not the intended recipient, please be advised that you are legally
prohibited from retaining, using, copying, distributing, or otherwise
disclosing this information in any manner. Instead, please reply to the
sender that you have received this communication in error, and then
immediately delete it. Thank you in advance for your cooperation.
---------------------------------------------------------------------
Please check that this email is addressed to you. If not, you should delete it
immediately as its contents may be confidential and its disclosure, copying or
distribution unlawful.
C. & J. Clark International Limited takes steps to prevent the transmission of
electronic viruses but responsibility for screening incoming messages and the
risk of such transmission lies with the recipient.
C. & J. Clark International Limited Trading as Clarks, Registered in England
number 141015.Registered office 40 High Street, Street, Somerset. BA16 0EQ.
England.
This message has been scanned for viruses by MailControl - www.MailControl.com
|
